Mikekennedy38 Posted June 7, 2020 Share #1 Posted June 7, 2020 Hope everyone is doing well. I came across this cannon and was to identify it. Any info is greatly appreciated! Sent from my iPhone using Tapatalk Link to post Share on other sites
BILL THE PATCH Posted June 7, 2020 Share #2 Posted June 7, 2020 I don't know but I love it. Would love that in my front yard.Sent from my moto g(7) play using Tapatalk Link to post Share on other sites
917601 Posted June 7, 2020 Share #3 Posted June 7, 2020 Antique? If you consider ( in my years of cannon collecting) maybe 1960's-80's repro, maybe suitable for signaling? The trunnions are all wrong ( not thick enough), are they below centerline or at the centerline? Without getting into much detail, one has to look at trunnion placement, iron " chaplets", bore diameter, bore sand casted or bored out? Link to post Share on other sites
917601 Posted June 8, 2020 Share #4 Posted June 8, 2020 Here is a Dutch fresh water recovered dating to late 1600-early 1700's , aquired from the Sarawak museum, Kuching, just before exports required government approval for exports. Sand casted bore with chaplets, ( chaplets are rusty iron like rods that are visible on the exterior used to center the bore when casting). All sand cored had chaplets and you can check with a magnet as some high grades the chaplets were peened over. No chaplets, not authentic. Mid 1700's bores were drilled out and the trunnions placed in line with the bore. On yours, vent placement, trunnion, reinforces, patina and muzzle fishy, typical of a modern repro. Check for a steel bore liner, if present, it would be suitable for signal rounds. Link to post Share on other sites
917601 Posted June 8, 2020 Share #5 Posted June 8, 2020 You can check " The Artilleryman" quarterly magazine past articles, one of which I have written on the subject of identifying early cannon and foundry techniques, repros, etc. Link to post Share on other sites
917601 Posted June 8, 2020 Share #6 Posted June 8, 2020 A few more pics. Link to post Share on other sites
Maxrobot Posted June 9, 2020 Share #7 Posted June 9, 2020 Interesting. Some questions first - Bore size? Does the bore go all the way to the vent? Is the vent connected to the bore? Does the carriage use any metal other than Iron? (For example - pot metal, steel,? Any screws? Is that a cotter pin holding the wheels on? There is a possiblity that it was sold by Bannermans'. Have you seen any old catalogs? Link to post Share on other sites
Mikekennedy38 Posted June 13, 2020 Author Share #8 Posted June 13, 2020 A few more pics.Thank you for all the info! Your cannon is awesome!Sent from my iPhone using Tapatalk Link to post Share on other sites
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now