Jump to content

Pile of M9 Bayonets, Numbers 1, 2 and 3.


Recommended Posts

I bought a pile of M9 knives pretty reasonably priced and am probably going to put them on my table at the next militaria show here in Arizona in May. I think some of them are commemorative pieces, some are civilian and a few are actual military issue. I think I'd like to keep one and wanted to get some input as to what I have here. Like I said, I got into them very reasonably priced so don't be afraid to tell me if some are absolute drek. If I get more than $20 a piece I am coming out ahead so no worries there.

The first three are in this post.

 

#1 is marked M9 LanCay USA on the matte silver blade, no other markings that I see. Plastic sheath is marked LANCAY beneath a sharpening stone on the reverse. Civilian model?

#2 is marked M9 Lan-Cay USA on the black blade, marked Lan Cay on the pommel. Plastic sheath marked Lan-Cay on reverse, no sharpening stone. Military issue?

#3 is marked M9 UTILITY on one side of the black bland US on the other side. Plastic sheath marked US below sharpening stone on the reverse. Fantasy piece?

 

post-2661-0-58038400-1522383008.jpg post-2661-0-01963300-1522383034_thumb.jpg

 

 

donation2013.gifdonation2014.gifdonation2015.gifdonation2016.gif
donation2017.gifdonation2018.gifdonation2019.gif






Always looking for Purple Hearts issued to New York men or any WWI Purple Hearts for 27th Division and 77th Division men.

Link to post
Share on other sites

Hi,

Nice batch of M9s.

No. 1 is a first contract LanCay with gray blade similar to the Phrobis III blades, but without the fuller.

No. 2 is likely a US contract M9, but the Lan-Cay on the pommel makes me less likely to say for sure. I believe the marked pommel was used on later Lan-Cay M9s with the ergo handle Not to forget that these modular systems can be switched around to anything you want.

No. 3 is strictly commercial, however the M9 Utility is collectable because they only made 900 of these. If it had a black handle and black sheath, it would be worth even more since they only made 100 of those.

Marv

Link to post
Share on other sites

I agree with Marv. I'm thinking the latch on 3 was replaced. Also the sheath on 1 would normally have the screwdriver on the cutter assembly on the bottom pointing down, also could have been changed at depot.

donation2014.gif

Link to post
Share on other sites
  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.