Jump to content

Knife and bayonet display I am working on...


MattS
 Share

Recommended Posts

  • 2 years later...
On 12/26/2017 at 10:05 AM, TALLYHO said:

Here is what I put together. I salvaged a couple 36"x 60" double locking door bulletin boards from a company I had worked for. I needed more depth than just one could provide so I took the cork backing off one and stacked it on top of another that I took the doors off of and fastened them together. I covered the cork backing with a burlap that I acquired at a local fabric shop. After mounting to the wall I drilled holes in the cork backing to accept 1/8" round metal rod stock cut to the length needed to support each individual knife. These rods were then covered with clear flexible plastic tubing cut to the appropriate length. Finished by installing a LED light ribbon around the interior top and sides.

post-6195-0-86692800-1514304254.jpg

 

Link to comment
Share on other sites

For bayonets I use peg board and cover the wire pegs with clear rubber tubing. But I also bend the peg for the muzzle ring 90 degrees.

y1.jpg

y2.jpg

y3.jpg

Link to comment
Share on other sites

  • 4 weeks later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...