Mark M Posted August 31, 2008 Share #1 Posted August 31, 2008 I picked these up yesterday at the ASMIC convention and would like to get some opinions on them. The wings appear to be a standard set of Vanguard NY produced wings but they have a very distinctive flare to them that gives the wings a 3D look from the front. Has onyine ever seen a set produced like this? Thanks, Mark Link to comment Share on other sites More sharing options...
Mark M Posted August 31, 2008 Author Share #2 Posted August 31, 2008 Reverse showing the trademark. Link to comment Share on other sites More sharing options...
Mark M Posted August 31, 2008 Author Share #3 Posted August 31, 2008 Now the side view showing the flare. The flare is done exactly the same on both sides. Notice also that the pin is the correct length for this set of wings. If this had been done to a standard set of wings the pin would have stuck out a lot more. Jeweler done perhaps? Link to comment Share on other sites More sharing options...
Mark M Posted August 31, 2008 Author Share #4 Posted August 31, 2008 Close up of the trademark and pin hinge. Link to comment Share on other sites More sharing options...
Mark M Posted August 31, 2008 Author Share #5 Posted August 31, 2008 Close up of the edge and pin latch. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now