Jump to content

Visor Cap Officer ASN help


Scarecrow
 Share

Recommended Posts

Scarecrow

I recently purchased this officer's "crusher type" visor cap. My question is concerning his ASN. As you can see his ASN starts with a W-. When did the US Army start using the O- for officers'? This cap may be early or slightly pre war, as it has a bound thick leather visor. Any help appreciated.

 

 

post-23999-0-09561100-1525221610.jpgpost-23999-0-27406400-1525221619.jpgpost-23999-0-48650700-1525221633.jpg

Link to comment
Share on other sites

Scarecrow

Thanks Matt! I must have 40-50 WWII US Officer;s visor caps in my collection and for those that are Id'd this is the first one I've had with a "W" prefix. Again, your input much appreciated.

 

Paul

Link to comment
Share on other sites

Paul, Im a big fan of the visor cap. Do you have a thread showing all of yours?

 

Me too! I lost count of how many caps I have, but W prefixes are rare. It's possible he either wore a regular officers cap badge instead of the WO one, or he was commissioned later on. Nice cap either way!

Link to comment
Share on other sites

Scarecrow

Paul, Im a big fan of the visor cap. Do you have a thread showing all of yours?

Beast,

 

Thanks for your comments. I don't have a posting showing my visor caps but when I get a few minutes I'll take a couple of photos. Quite a few are on mannequins so a little difficult to get a "group" shot but will do my best.

 

Thanks again.

Link to comment
Share on other sites

Scarecrow

 

Me too! I lost count of how many caps I have, but W prefixes are rare. It's possible he either wore a regular officers cap badge instead of the WO one, or he was commissioned later on. Nice cap either way!

Matt,

 

Again thanks for your comments, much appreciated. Another question, if the "W" is for Warrant Officers would Air Corps Flight Officer ranks have used the "O"?

 

Paul

Link to comment
Share on other sites

Not 100% sure...

 

From Wiki:

During World War II, the Army also expanded the service number prefixes to include several new one letter designators in addition the original three prefixes (R, F, and O) which had been created after World War I. In all, the following prefixes were used during World War II.

A: Used by female members of the Women Army Corps

F: Used by field clerks during the First World War

K: Used by female reserve and specialist officers with service numbers 100 001 and higher

L: Used by enlisted members of the Women's Army Corps

N: Used by female nurse officers

O: Used by Regular Army officers

R: Used by Army enlisted personnel with service #s from 1 to 5 999 999 upon reenlistment

T: Used by flight officers appointed from an enlisted status

V: Used by officers of the Women Army Corps

W: Used by Regular Army Warrant Officers

Link to comment
Share on other sites

Scarecrow

Paul, Im a big fan of the visor cap. Do you have a thread showing all of yours?

Hi Beast.

 

Here are some photos of some of my visor caps. I have quite a few more but they are RAF, RCAF, Polish, ATA, and RAF Ferry Command, so not sure I can show those. Do not want to violate Forum policy about non US items. Took these photos quickly with my IPhone so not best quality. The last two photos are of three of my favorites. The very poor shots behind glass are of two of my Id'd AVG caps. One belonged to Bill Reed and the other George Paxton. The last one is a pilot from the Mexican 201st Fighter Squadron. The 201st was assigned to the US 58th Fighter Group and flew P-47's in the Philippines. Since they flew with and were assigned to a US group I hope its Ok to show this photo. This cap was made in Mexico City. Also, as you can see I have many of my caps on mannequins and not just displayed on shelves. Hope you enjoy the photos.

 

Paul

post-23999-0-68691300-1525729653.jpgpost-23999-0-79185400-1525729663.jpgpost-23999-0-93713800-1525729674.jpgpost-23999-0-79613400-1525729685.jpgpost-23999-0-36364600-1525729696.jpgpost-23999-0-00315100-1525729703.jpgpost-23999-0-47920000-1525729714.jpg

Link to comment
Share on other sites

Fantastic! That Mexican cap is top notch! Do you put any material between the Styrofoam heads and the caps?

Hi Erick,

 

Yes, I cut out a circular piece of cotton cloth, just large enough to cover the entire crown. Then secure it with a common pin in the center of the disc into the Styrofoam. Hasn't failed me yet.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...